No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Adding an Eth-trunk by the Interface on the Layer 2 Board Fails on the NE40 VRP5.3 Version

Publication Date:  2012-07-27 Views:  51 Downloads:  0
Issue Description
The interface on the Layer 3 board can be bound to the Eth-trunk on the NE. However, the interface on the Layer 2 cannot be bound to the Eth-trunk. 
 
Alarm Information
The following alarm information is displayed when the default VLAN is configured for an Eth-Trunk interface:
[r1-a-gdqy-gdwt-Eth-Trunk2]port default vlan 201
Routed VLAN should not have aggregation port 
 
Handling Process
Perform the following in sequence to add an interface to the Eth-Trunk.
[Quidway]interface Vlanif 201
[Quidway-Vlanif201]undo property routing
Info:This VLAN interface is of bridging property!
[Quidway-Vlanif201]quit
[Quidway]int Eth-Trunk 1
[Quidway-Eth-Trunk1]port default vlan 201 
 
Root Cause
Based on the prompt, you may conclude that the fault is caused by incorrect configuration. 
Suggestions
It is recommended not to configure the property routing command in the VLANIF when the Eth-trunk is configured on the Layer 2 board of the NE40 VRP5.3 version. 

END