No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FAQ-Why Cannot Operators Enter the EPON Board Configuration Mode on the MA5680T of the V800R006C02 Version

Publication Date:  2012-07-25 Views:  46 Downloads:  0
Issue Description
Q:
Why cannot operators enter the EPON board configuration mode on the MA5680T of the V800R006C02 version?
Alarm Information
Null
Handling Process

A:
In the global config mode, input interface, and then input ?. It is found that the EPON mode character is not displayed. If interface epon is input directly, the following error is displayed:
(config)#interface ?
---------------------------------------------                                   
  Command of config Mode:                                                       
---------------------------------------------                                   
adsl                  Change into ADSL command mode                             
emu                   Enter an environment monitor unit                         
eth                   Change into ETH command mode                              
giu                   Change into GIU command mode                              
gpon                  Change into GPON command mode                             
loopback              LoopBack interface                                        
meth                  MEth interface                                            
null                  NULL interface                                            
opf                   Change into OPF command mode                              
scu                   Change into SCU command mode                              
shl                   Change into SHL command mode                              
top                   Change into TOP command mode                              
top-stm1              Change into STM1 command mode                             
vdsl                  Change into VDSL command mode                             
vlanif                VLAN interface                                            
(config)#
The cause is as follows: On the MA5680T of the V800R006C02, two xPON service configuration modes are supported: distributing mode and profile mode. In the distributing mode, the EPON service is not supported. In the profile mode, both EPON service and GPON service are supported.
The following command is used for switching between two configuration modes:
(diagnose)%%xpon mode switch-to ?                            
---------------------------------------------                                   
  Command of diagnose Mode:                                                     
---------------------------------------------                                   
modetype<E><distributing-mode,profile-mode>                                     
                      Configured mode                                           
(diagnose)%%

Root Cause
Null
Suggestions
Null

END