In P country,N project create IP transmission network by IP packet MW RTN900V1R1CO2,the network is line, and batch 2 has some hybrid MW RTN600V1R3 mix
with RTN900R1, but U2000 can't monitor the last hop RTN600 (NMS port connect between RTN600 and RTN900 in same site), according the plan, PTN(PTN900 upgrade to RTN900) and optical network NE partition by extend ID in the same server U2000, PTN extend ID=9,optical NE extend ID=8, IP address in the
Using Navigator login RTN900 which is connect RTN600 directly by NMS port
1,Add IP of RTN600 in static route table :cm-add-lanroute:129.9.X.X,255.255.255.255,129.9.X.X; and query the route table check the IP :cm-get-routetable;
2,Query OSPF status :cm-get-ospf-interface; and enable the OSPF protocol of LAN interface :cm-set-ospf-interface:lan,enable;
3,Enable the diffuse function of static route,Diffuse the IP which added to static route table to OSPF domain :cm-set-ospf-import:static,enable;
4,Login GNE,check the IP in his route table,query the route table :cm-get-routetable;
5,Ping the IP of RTN600 and login RTN600 successfully by Navigator (But can't create the RTN600 by U2000)
6,Change the extand ID=8 to ID=9 of RTN600 same RTN900's extand ID and create the NE by U2000 successfully.
IP packet MW RTN900V1R1 not support extend ECC function,them communication by inband DCN and route protocol with each NE,RTN600 support extend ECC
and route protocol(OSPF and RIP). Using Navigator login RTN900 which is connect RTN600 directly by NMS port. query the coreroute ":cm-get-coreroute" can't get the ID of RTN600, query the route table ":cm-get-routetable" also can't get the IP of RTN600.
Understand the knowledge of route protocol as well and interrelated command of Navigator(Some function can't actualize by U2000)