No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Due to disabling TDC-ADJUSTENABLE function high Bit errors on NS3 card

Publication Date:  2012-07-25 Views:  32 Downloads:  0
Issue Description
8 OSN 6800 are configured for making 40G DWMD ring 
NE version is 5.51.05.35 NMS version is U2000V100R001C00SPC003
Alarm Information

BEFFEC-EXC


Handling Process
Cheked the Tx and Rx power on far end and local side,but both are fine 
check the powers of all pass throughs on MCA there was no such variation on pass through channels 
Check the board performance ,all performances were fine 
When check the dispersion parameters the TDC-ADJUSTENABLE function was disable ,when enable this function all errors were cleared 
Root Cause
1. Optical power value issue: need check whether it is low or high onwhole span including all pass throughs on MCA 
2. OSNR issue:  need check the link power
3. Dispersion issue: if all wavelength have the same poor FEC-BEF-BER, consider dispersion issue
4. hardware issue ,need to replace 
Suggestions
Always suggested to enable TDC-ADJUSTENABLE function ,otherwise due to this the 40 G card will generate errors

END