Questo sito utilizza cookie di profilazione (propri e di terze parti) per ottimizzare la tua esperienza online e per inviarti pubblicità in linea con le tue preferenze. Continuando a utilizzare questo sito senza modificare le tue preferenze acconsenti all’uso dei cookie. Se vuoi saperne di più o negare il consenso a tutti o ad alcuni cookie clicca qui>
The website that you are visiting also provides Arabian language. Do you wish to switch language version?
يوفر موقع الويب الذي تزوره المحتوى باللغة العربية أيضًا. هل ترغب في تبديل إصدار اللغة؟
The website that you are visiting also provides Russia language Do you wish to switch language version?
Данный сайт есть в английской версии. Желаете ли Вы перейти на английскую версию?
Topology: USG5320 (port 1: 22.214.171.124)--------Layer-2 switch--------China Telecom device (126.96.36.199)
USG5320 (port 2: 188.8.131.52)--------Layer-2 switch--------CNC device (184.108.40.206)
The USG5320 is connected to the China Telecom device through a Layer-2 switch. You are required to check whether a switchover to the link between the USG5320 and the CNC device is performed when the link between the USG5320 and the China Telecom device is down.
Note: The previous addresses are for example only.
Run the ip-link command on the USG5320 to check a specified IP address by ICMP or ARP (by default, ICMP). If the command finds that the address is inaccessible, the USG5320 considers that the link to the China Telecom device is down.
Note: This command can check only addresses on the same network segment as the firewall port. Moreover, the address to be checked must be the gateway address.
On the USG5320, run the ip-link command to check whether the IP address, 220.127.116.11, of the China Telecom device is reachable. If no, the static routing regards that this link is down (two default routes are configured) and switches to the link to the CNC device.
ip-link check enable
ip-link 1 destination 18.104.22.168
Fault 1: The USG5320 can detect a connection failure between itself and the Layer-2 switch.
Fault 2: The USG5320 cannot detect a connection failure between the Layer-2 switch and the China Telecom device, because the link between the USG5320 and the Layer-2 switch is up.
If the switch between the USG5320 and the China Telecom device is a Layer-3 switch and the firewall interface address and the China Telecom device address are not on the same network segment, do not use the ip-link command to check the gateway address.