No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>

Reminder

To have a better experience, please upgrade your IE browser.

upgrade
MENU

FAQ-Implement the MIB (OID from MIB) into Monitoring System

Publication Date:  2015-05-20 Views:  279 Downloads:  0
Issue Description
We have tried to implement the MIB (OID from MIB) into our Monitoring System, but so far with no success.
The SNMP credentials and also version v2c should be fine.

The monitoring system connects to the Storage via SVP Server (IP: 10.200.0.41) using as an example the OID:
1.3.6.1.4.1.34774.4.1.23.5.1.1.2 for HW – Info – Disk – Health – Status with a type of Gauge unsigned

From MIB Importer:
-------------------------




How we setup this sensor on the monitoring system:





But at the end we don’t receive any data back from 18500 storage:

Received Error Message is: No such object (SNMP error # 222)

Do you have any idea why we are getting no data back from 18500 system?
If you need, we can also join a remote session together in order to verify things…
Solution
Customer is having V1 firmware. They need to check the MIB-OID table values to see if are correct fill in to not be miss a “ . “ or to put an number in plus or in minus.

Please see bellow the link from where you can get the MIB table values

http://support.huawei.com/enterprise/NewsReadAction.action?newType=0301&contentId=NEWS1000005128&idAbsPath=0301_10001|1382082906220

Related to this issue we need checking the following steps:

1. please check SNMP v2c was enabled or not?

admin:/>show snmp version                     SNMP V1V2C Switch : Off
2. If not, please enable the SNMP v2c with below command:

admin:/>change snmp version v1v2c_switch=On

CAUTION: You are about to enable SNMPv1 and SNMPv2c. But you are advised to use the secure SNMPv3 protocol only.
Do you wish to continue?(y/n)y
Command executed successfully.

3. If the problem is still there, please change the community name with below command to make sure they are right.

Example
To change the SNMP read-only community string to readstor and the read/write community string to writestor, run the following command:

admin:/>change snmp community read_community=readstor write_community=writestor
Command executed successfully.

END