No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Fault ocurred in MM910

Publication Date:  2015-09-12 Views:  75 Downloads:  2
Issue Description

We lose connection to the HMM, the MM we were using was the MM910 with the software version (U54)2.20. Attached is the documentation for the network planinng.

At the point were we have the error was when we have installed the FusionCompute and the FusionManager but we need different Switche's so we take out the 2X and 3X SW and replace them for the 1E and 4E, for this we power off the hole Chasis replace the SW´s for the new ones and power the Chasis again, we cannot connect to the HMM but we can connect to the FusionCompute and FusionManager.

Alarm Information
We connect to the KVM on the front view of the Chasis and appear the alarm "Transition to non-recoverable from less severe".
Handling Process
We power off the Chasis again take out the new Switches and put back the old ones, because this was the only configuration we made before the system went down, so we powered on again the Chasis and the alarm was gone and the system has no fault at all. So later we put back the New Switches keeping the old ones on their position and no fault also, so we keep this configuration.
Suggestions
If you have the same case just keep the position of the Switches you use.

END