No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

RH2488 V2 - set the virtual drives in BIOS

Publication Date:  2016-01-20 Views:  57 Downloads:  0
Issue Description

Customer wanted to configure virtual drives in BIOS.

His server type is RH2488 V2.

 

RH2488 V2, after the virtual drive mounted via virtual media, press F11, and sometimes do not see the virtual drive (USB: AMI Virtual CD), and can only see physical CD-ROM (USB: TEAC DV-28S-W), at this timeYou need to go into the BIOS to set the drive sequence.

For the 1.0 version of the BIOS, in Boot >> CD / DVD / Drives in order to set up the drive, the following two shown below:

Solution

The steps about the virtual drives configuration in BIOS are below:

After the virtual drives were mounted via virtual media, press F11. Sometimes, we cannot see the virtual drive, but we can see only the physical CD-ROM. Then, you need to go into BIOS and set the drive sequence.

1.  For the BIOS version 1.0 -> go to Boot tab, select CD / DVD / Drivers in order to set up the drive. Follow the steps below:

2. For the BIOS version 1.0a, go to Boot tab, select the CD / DVD Drives and will show the 1st Drive [Not Installed]. So, we need to set it. Go to Boot tab, select the USB Drives. Follow the pictures from BIOS to see the needed steps:

 

END