No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionCube builder failed to install UVP on E9000 blades

Publication Date:  2016-11-20 Views:  268 Downloads:  0
Issue Description
None
Handling Process
None
Solution

FusionCube builder failed to install UVP on E9000 blades

Keywords:

FusionCube,E9000, CNA, Installer

Product:

FusionCube, E9000, CH222 V3 , CH121 V3 , CH220 V3

Fault Type:




Language:

English


Problem Description:

We create Hyper-Converged infrastructure for one of the customer so during the installation we faced UVP
OS failed to install, after below solution the FusionCube installer start the installation of UVP successfully…


Solution:


Login to MM E9000 by using putty

Then issue below commands to check port mode if the result is like below so kindly change it as per the instruction




Input this command to change Outportmode

# smmset -d outportmode -v 0



Also make sure your laptop connected to correct Stack port..




Then restart the installer from FusionCube builder.



END