No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

DHCP L2 and Circuit-ID configuration using Option82

Publication Date:  2017-11-29 Views:  418 Downloads:  0
Issue Description


The client use DHCP Relay and he is requiring a CIRCUIT- ID for DHCP Option 82. Syntax of CID for DHCP Option 82 is the following :

Circuit ID= <Equipment_ID>#n1#n2#n3:n4.n5.n6

<Equipment_ID>= xxIP_hex where xx=03 and IP is the IP address of the OLT

n1 - constant value „01”


n2 - id of slot GPON board, this numer should consist of two digits: eg. „03”

n3 - id of port in GPON board. This numer should consist of two digits: eg. „03”. Value must start from 1, if ports are numerated start 0, n3=port_id+1

n4 - ONT id. This numer should consist of three digits: eg. „003”. Value must start from 1, if ports are numerated start 0, n4=port_id+1

n5 - constant value „01”

n6 - id of UNI port of ONT.



 



Solution


For configuring DHCP in L2 IPv4, you have to follow the next steps (example):

1. Configure a service vlan :

# vlan 100 smart


2.     Add the upstream port to vlan
# port vlan 100 0/19 0

3.  Add the service- port to vlan
# service-port vlan 100 eth 0/16/0 multi-service user-vlan untagged tag-transform default

4.     Enable dhcp-option82:

# dhcp option82 enable


5.    Apply raio-mode and raio-format:

# raio-mode user-defined dhcp-option82

# raio-format dhcp-option82 cid xpon anid anip
"hex" "#" "01" "#" slot02 "#"
port02 ":" ontid+1 "." "01" "."
ontportid


For DHCP L2 configuration, no other commands to configure on OLT.  You have also to make some configuration on DHCP server, like rental period, update cycle and address allocation pool. For this, please consult the DHCP server manual.


END