No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

PBR of Intelligent Uplink Selection base on Load balancing

Publication Date:  2018-05-18 Views:  140 Downloads:  0
Issue Description

Customer wants to configure PBR of Intelligent Uplink Selection base on Load balancing by link bandwidth on Firewall 6300 V100R001C30SPC900.

The uplink topology is below :


Solution

1、 You should configure the gateway on the two uplink interface ,like the below command :

[USG6300] interface GigabitEthernet1/0/1

[USG6300- GigabitEthernet1/0/1]ip address 201.1.1.1 24

[USG6300- GigabitEthernet1/0/1]gateway 201.1.1.2  //must configuring Gateway

[USG6300- GigabitEthernet1/0/1]quit

[USG6300] interface GigabitEthernet1/0/4

[USG6300- GigabitEthernet1/0/4]ip address 204.1.1.4 24

[USG6300- GigabitEthernet1/0/4]gateway 204.1.1.5   //must configuring Gateway

[USG6300- GigabitEthernet1/0/4]quit

2、 Then configure the policy-based-route ,like below command :

[USG6300]policy-based-route

[USG6300-policy-pbr]rule name pbr1

[USG6300-policy-pbr-rule-pbr1]source-zone trust

[USG6300-policy-pbr-rule-pbr1]source-address address-set add1

[USG6300-policy-pbr-rule-pbr1]action pbr egress-interface multi-interface

[USG6300-policy-pbr-rule-pbr1-multi-inter] add interface GigabitEthernet1/0/1

[USG6300-policy-pbr-rule-pbr1-multi-inter] add interface GigabitEthernet1/0/4

Under egress-interface multi-interface view , we can configure the uplink selection mode for policy-based routes , according to customer requirement ,we will choose Load balancing by link bandwidth mode .

[USG6300-policy-pbr-rule-pbr1-multi-inter] mode proportion-of-bandwidth

 


END