FAQ-What Is the Meaning of Each Flag in the display fib Command Output

Publication Date:  2012-07-27 Views:  292 Downloads:  0
Issue Description
 Q:
What is the meaning of each flag in the display fib command output? 

 
Alarm Information
 Null 

 
Handling Process
 A:
At present, the display fib command output displays the following flags:
B: indicates the blackhole routes, routes with the outgoing interface being Null0.
D: indicates the routes generated by a dynamic routing protocol, such as IS-IS, OSPF, BGP, or RIP.
G: indicates the gateway routes, routes destined to a gateway.
H: indicates the host routes.
L: indicates the routes generated by ARP or ISIS. This kind of route is usually generated in the scenario where VLAN-ARP is enabled.
S: indicates the static routes, which are configured through the ip route-static command or generated through the corresponding NMS operations.
C: indicates the direct routes with the non-3-bit masks that are generated on the VLAN interface.
F: indicates the routes generated by the static ARP.
U: indicates that a specific route is unreachable.
V: indicates the routes generated on the interface configured with the destination VRF. 

 
Root Cause
 Null 

 
Suggestions
 Null 

 

END