User connect with the private line by the ADSL interface card, the mode of obtain the address is that the upstream support the fix IP, no need to dial-up by using the account and the password. When configure the interface card, the command of PVC failed, the commands are as below:
map bridge Virtual-Ethernet1
input the commands failed:
<0-255>/<32-65535> Enter value of VPI/VCI
Error: Set failed!
1. The interface don’t know the pvc 8/35, it’s means that is single PVC,we can change it by modify pvc. But after the input of this command, when we input map bridge Virtual-Ethernet1, clew that this operation isn’t supported.
[USG2130BSR-atm-pvc-Atm2/0/0-8/35]map bridge Virtual-Ethernet 1
Info:This card does not support this operation.
2. the interface card is single PVC, so the interface ATM no need to configure the pvc 8/35, means that no need to configure the map bridge Virtual-Ethernet1, we can configure the fix IP supplied by the upstream.
1. ADSL interface card abnormity
2. Configuration un-correct
3. Equipment not support etc.
PVC command is used for the multi-PVC of the ATM interface, no need to tie up the VT port.