After installing Ultrapath it failed and asking for disabling MPIO
Ultrapath failed , please disable MPIO before continuing
Script Example: Configuring MPIO using PowerShell:
In this example, I wish to perform the following tasks:
Tip: If these steps are performed prior to connecting devices of the desired BusType, you can typically avoid the need for a restart.
• Install the MPIO feature on a new Windows Server 2012 installation.
• Configure MPIO to automatically claim all iSCSI devices.
• Configure the default Load Balance policy for Round Robin.
• Set the Windows Disk timeout to 60 seconds.
Here is what this script would look like:
# Enable the MPIO Feature
Enable-WindowsOptionalFeature -Online -FeatureName MultipathIO
# Enable automatic claiming of iSCSI devices for MPIO
Enable-MSDSMAutomaticClaim -BusType iSCSI
# Set the default load balance policy of all newly claimed devices to Round Robin
Set-MSDSMGlobalDefaultLoadBalancePolicy -Policy RR
# Set the Windows Disk timeout to 60 seconds.
Set-MPIOSetting -NewDiskTimeout 60
# Disable the MPIO Feature
Disable-WindowsOptionalFeature -Online -FeatureName MultipathIO
One the same host it can't be 2 multipathing software to be enabled , so one of them must be disabled first
Huawei recommend using it own ultrapath