NX112配置堆叠

发布时间:  2015-03-03 浏览次数:  429 下载次数:  0
问题描述
NX112配置堆叠。
处理过程
1、2个交换板的堆叠端口进行对接,5分钟后自动堆叠成功

[Quidway]dis stack
Stack topology type: Link
Stack system MAC: ac4e-9163-2250
MAC switch delay time: 10 min
Stack reserved vlanid : 4093
Slot#     Role        Mac address      Priority   Device type
-------------------------------------------------------------
    0     Master      ac4e-9163-2250   100        S5328C-EI-24S
    1     Standby     ac4e-9163-2270   100        S5328C-EI-24S

2、2个交换机各自外出一个网卡连接到上层交换机,配置配置E-TRUNK

[Quidway]int eth 10
[Quidway-Eth-Trunk10]port li
[Quidway-Eth-Trunk10]port link-type trunk
[Quidway-Eth-Trunk10]port trunk allow-pass vlan all
[Quidway-GigabitEthernet0/0/21]eth-trunk 10
[Quidway-GigabitEthernet1/0/21]eth-trunk 10

[Quidway]dis eth-trunk
  INTEGER<0-63>  Trunk ID
  |              Matching output
  <cr>         

[Quidway]dis eth-trunk 10
Eth-Trunk10's state information is:
WorkingMode: NORMAL         Hash arithmetic: According to SA-XOR-DA         
Least Active-linknumber: 1  Max Bandwidth-affected-linknumber: 8            
Operate status: up          Number Of Up Port In Trunk: 2                   
--------------------------------------------------------------------------------
PortName                      Status      Weight
GigabitEthernet0/0/21         Up          1    
GigabitEthernet1/0/21         Up          1    

3、上层交换机对应的2个连接端口也配置E-TRUNK
   配置步骤参考NX220配置E-trunk 步骤

END