FAQ-MA5200G MA5000G 配置eth-trunk接口不支持静态LACP?

发布时间:  2015-05-04 浏览次数:  186 下载次数:  0
问题描述

MA5200G 配置eth-trunk接口不支持静态LACP配置命令,在ETH-TRUNK接口下没有mode 模式更改命令,当前版本是MA5200G V300R003C01B056,如下:

[HTTX-MA5200G-Eth-Trunk2]?             //直接?显示视图下所有支持命令
Eth-trunk interface view commands:
  arp                ARP module
  arp-proxy          ARP(Address Resolve Protocol) proxy configuration command
  assp               Specify interface parameters for ASSP
  bas                BAS view
  clear              Clear current setting
  cluster            Specify cluster configuration information
  control-flap       Interface flap control enable
  debugging          Debugging command
  description        Specify interface description
  dhcp-server        Dhcp server
  display            Display
  dpi                Configure the DPI switch of this port
  enable             Enable function
  fast-switch        to set fast-switch
  icmp               Specify ICMP configuration information
  igmp               Specify parameters for IGMP
  ip                 IP interface configuration commands
  ipv6               Specify IPv6(Internet Protocol Version 6) configuration
                     information
  isis               Configure interface parameters for ISIS
  l2                 Config Layer2 bridge interworking
  least              least active-linknumber configuration
  load-balance       set trunk load-balance arithmetic
  local-ce           Local ce configuration information
  mac-address        MAC address
  max                Set trunk max bandwidth-affected-linknumber
  mpls               Specify MPLS(Multiprotocol Label Switching) configuration
                     information
  mtu                Specify Maximum Transmission Unit(MTU) of the interface
  multicast          Multicast information
  multicast-vlan     Display multicast info
  ndp                Neighbor discovery protocol
  ntdp               Specify NTDP configuration information
  ntp-service        Specify NTP(Network Time Protocol) configuration
                     information
  ospf               OSPF interface commands



[HTTX-MA5200G]dis ver
Huawei Versatile Routing Platform Software
VRP (R) software, Version 5.30 (MA5200G V300R003C01B056)              //当前版本
Copyright (C) 2000-2006 Huawei Technologies Co., Ltd
Quidway MA5200G-2 uptime is 189 weeks, 5 days, 4 hours, 6 minutes
Patch: V300R003SPH019
 
SMU 3(Master) : uptime is 189 weeks, 5 days, 4 hours, 6 minutes
  1024M    bytes SDRAM
  16M      bytes Flash Memory
  128K     bytes NVRAM
  38G      bytes Hard Disk
  Pcb      Version : H521SMU REV 0
  Logic    Version : 005
  BootROM  Version : 006-026
  Bas      Version : 5200-33105619
  Software Version : VRP (R) software, Version 5.30 (MA5200G V300R003C01B056)
  BarCode          : 0376191095000007
 
  Clock:
    StartupTime   2011/09/03   10:39:29
    Pcb      Version : H521CLK REV B
    Epld     Version : 016
    Software version : 021

解决方案

经确认,V300R003版本在3372版本之前都不支持配置LACP,从3372开始的版本是支持mode lacp-static,当前设备版本是3356,不支持lacp。

附V300R003的lacp配置:
interface Eth-Trunk1
  mode lacp-static

END