FAQ-How Do I Configure the Cisco Channel-Group Mode if the Eth-Trunk Interface Is Connected to a Cisco Device

Publication Date:  2015-06-30 Views:  291 Downloads:  0
Issue Description
How Do I Configure the Cisco Channel-Group Mode if the Eth-Trunk Interface Is Connected to a Cisco Device?
Solution
The Eth-trunk interface is static and does not run any protocol. Every Eth-trunk member interface can receive and send packets. The Cisco channel-group mode must be set to on, indicating no negotiation. (The command is channel-group [num] mode [ auto | on | desirable ], in which auto indicates passive negotiation, on indicates no negotiation, and desirable indicates proactive negotiation.)

If the USG Eth-trunk interface is connected to a Huawei switch, the link-aggregation mode must be set to manual.

END