FAQ-What does a user do when the screen controlled by the remote control is not displayed on the VP9035A

Publication Date:  2015-08-06 Views:  80 Downloads:  0
Issue Description
What does a user do when the screen controlled by the remote control is not displayed on the VP9035A?
Solution
HD OUT 1 and SD OUT 1 must be used separately on the VP9035A. Figure 7-1 shows the two video output interfaces.

Figure 7-1 Interfaces on the rear panel of the VP9035A




This fault can be rectified in either of the following ways:

Enabling or disabling the SD video interface

1. Open the web browser.

2. Enter the IP address of the HD terminal (default: 192.168.1.1).

3. Enter the user name and password (default: both are admin), and click Log In.

4. Choose System Settings > Input/Output > Video Output > Common Settings. The page shown in Figure 7-2 is displayed.

Figure 7-2 Enabling or disabling the SD output interface




5. If the SD output interface is enabled, select Enable. Otherwise, select Disable.

6. Save the settings.

Using the remote control to display the screen


Hold down (new remote control) or (old remote control) for about 15 seconds to display the screen on the video output device.

END