Related information about the product and version: the T3500
Every time when the T3500 that is not configured with the RAID card is started, the OS is booted through the network. As shown in Figure 2-29, the OS cannot be booted through the hard disk. Figure 1-1 BIOS boot interface
Step 1 Restart the device and press the DEL button to enter the BIOS interface.
l Two steps for power-on and power-off: After receiving the power-off command, power supplies of different levels are powered off in succession; after receiving the power-on command, power supplies of different levels are powered on in succession.
l One step for restart: After receiving the restart command, all modules are reset once. During this process, the device will not be powered off. Step 2 On the IPMIBoot interface, set 1st Boot Device to SCSI, and then save the settings by selecting Send to BMC, as shown in Figure 2-29. Figure 1-1 BIOS boot interface
Step 3 Press the F10 to save and exit. If the OS can be booted through the hard disk after the device is restarted, the fault is removed.
Since the BIOS boot option is set to the network boot mode, the OS is booted through the network every time.