To have a better experience, please upgrade your IE browser.upgrade
Questo sito utilizza cookie di profilazione (propri e di terze parti) per ottimizzare la tua esperienza online e per inviarti pubblicità in linea con le tue preferenze. Continuando a utilizzare questo sito senza modificare le tue preferenze acconsenti all’uso dei cookie. Se vuoi saperne di più o negare il consenso a tutti o ad alcuni cookie clicca qui>
The website that you are visiting also provides Arabian language. Do you wish to switch language version?
يوفر موقع الويب الذي تزوره المحتوى باللغة العربية أيضًا. هل ترغب في تبديل إصدار اللغة؟
The website that you are visiting also provides Russia language Do you wish to switch language version?
Данный сайт есть в английской версии. Желаете ли Вы перейти на английскую версию?
The networking diagram is shown in Figure 3-1.
In the network, USG A adopts the IP-Prefix list to filter the route received from USG B.
The configuration on USG A:
# ospf 100 # ip ip-prefix rta index 20 deny 126.96.36.199 32 #
The configuration on USG B:
# OSPF 200 # network 188.8.131.52 255.255.255.255 network 184.108.40.206 255.255.255.255 #
Run the display ip routing-table command to view the route received on USG A. The route 220.127.116.11/32 should be received. The route does not appear in the routing table.
To locate the fault, follow the steps described below:
Check the routing table on USG B to confirm whether all the routes are advertised to USG A.
On USG B, run the display ip routing-table command to display information of the routing table. If the routes 18.104.22.168/32 and 22.214.171.124/32 have been advertised to USG A, the fault occurs on USG A.
Check the OSPF configuration on USG A to confirm if the filter is enabled when the route is received.
On USG A, run the display current-configuration configuration ospf command to check the ospf configuration. If the IP-Prefix filter is adopted when USG A receives the route from USG B, there is a possibility that all the routes are filtered out.
Check the configuration of the IP-Prefix list and confirming if the route is filtered out by the IP-Prefix list.
On USG A, run the display ip ip-prefix rta command to view the filter configuration. If only the route 126.96.36.199/32 is configured with deny but the route 188.8.131.52/32 is not configured with permit. Thus, the fault is located.
When USG A adopts the IP-Prefix list to filter the route received from USG B and for the non-matched route, the system returns deny by default. The route 184.108.40.206/32 is , therefore, filtered out.
When only the deny node is configured in the IP-Prefix list, the route outside the matching address/mask range is denied by default.
Configure the permit node to allow the specified route to pass through, or after the deny node is configured, define an entry of permit 0.0.0.0 0 greater-equal 0 less-equal 32 to permit all routes to pass through.