The 10GE LPU board of EH1D2X08SED4 can't be registered when plugged into slot4 of S9700 frame with factory software version.
S9706's Device status:
Slot Sub Type Online Power Register Alarm Primary
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
4 - - Present PowerOn Unregistered - NA
6 - EH1D2T36SEA0 Present PowerOn Registered Normal NA
7 - EH1D2SRUDC00 Present PowerOn Registered Normal Master
8 - EH1D2SRUDC00 Present PowerOn Registered Normal Slave
PWR1 - - Present PowerOn Registered Normal NA
PWR2 - - Present PowerOn Registered Normal NA
CMU1 - EH1D200CMU00 Present PowerOn Registered Normal Master
FAN1 - - Present PowerOn Registered Abnormal NA
FAN2 - - Present PowerOn Registered Normal NA
1.ask FSE to provide the barcode of the LPU board, confirmed that its board type was EH1D2X08SED4.
2.checked in the handbook of "S9700 Hardware Description", the following information was found that the new LPU board of EH1D2X08SED4 can only be used in V2R2 and later versions.
The EH1D2X08SED4 is supported in V200R002C00 and later versions
3.provide the suggest deployment version for s9700: upgrade the s9706 software version to V200R002C00SPC100 plus patch V200R002SPH001, here is the download link:
The factory version V200R001C00SPC300 of S9700 frame can't support the new LPU board of EH1D2X08SED4.
The factory version of S9700 frame should support all the possible LPUs or MPU and other boards, so that customer can use it directly. Otherwise, it may be considered as DOA issue.
(Now this suggestion was implemented.)