No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our Private policy>

Reminder

To have a better experience, please upgrade your IE browser.

upgrade
MENU

FAQ-How to Check Whether the Cable on an Ethernet Interface Is Working Properly?

Publication Date:  2014-09-12 Views:  2439 Downloads:  0
Issue Description
FAQ-How to Check Whether the Cable on an Ethernet Interface Is Working Properly?
Alarm Information
None
Handling Process
FAQ-How to Check Whether the Cable on an Ethernet Interface Is Working Properly?

A: Run the virtual-cable-test command to test the cable on an Ethernet interface.
For example:
Test the cable connected to Ethernet electrical interface Ethernet 0/0/1.
<Quidway> system-view
[Quidway] interface Ethernet 0/0/1
[Quidway-Ethernet0/0/1] virtual-cable-test
Warning: The command will stop service for a while, Continue [Y/N]?y
Pair A length: 189meter(s)
Pair B length: 189meter(s)
Pair C length: 189meter(s)
Pair D length: 189meter(s)
Pair A state: Ok
Pair B state: Ok
Pair C state: Ok
Pair D state: Ok  

NOTE:
Status of a circuit pair of the cable.
OK: indicates that the circuit pair is terminated normally.
Open: indicates that the circuit pair is not terminated.
Short: indicates that the circuit pair is short circuited.
Crosstalk: indicates that the circuit pairs interfere with each other.
Unknown: indicates that the circuit pair has an unknown fault.
Root Cause
None
Suggestions
None

END