Failure to Report an Extension Error to the VSM

Publication Date:  2012-07-23 Views:  108 Downloads:  0
Issue Description
An NE just returns a general error message. Hence, Users are unaware of what caused the configuration failure or how to change parameters during next configuration.

This case is applicable to routers and switches.
Alarm Information
None
Handling Process
Step 1     Telnet to an NE. Run the system command to open the system view. Then, run the following command to check whether the SNMP extend error code function is enabled on the NE.
disp current-configuration configuration | incl snmp-agent extend
If a blank message is displayed, the function is disabled on the NE.
Step 2     Run the following command to enable the function:
snmp-agent extend error-code enable
Step 3     Repeat Step 1 to verify the configuration.
display current-configuration configuration | incl snmp-agent extend
If the following information is displayed, the function is enable on the NE.
snmp-agent extend error-code enable
 
Root Cause
The SNMP extension error code function is not enabled on the NE.
Suggestions
None

END