USG3040 Dual-System Hot Backup-state of HRP in secondary firewall is abnormal as it always stay at initialization state.

Publication Date:  2012-09-13 Views:  461 Downloads:  0
Issue Description
Take USG3040 as primary/secondary, the switch is normal. But when the primary/secondary wall change from primary to secondary, the status of HRP not normal, primary wall HRP is normal, VRRP is normal.
If to enable the HRP of secondary wall or shutdown the download interface, secondary wall HRP get right.

Abnormity of HRP as below:
<yt-fw_s>disp hrp
The firewall's config state is: INITIALIZE
configurations:
#
interface GigabitEthernet0/1
ip address 172.16.0.253 255.255.255.0
vrrp vrid 1 virtual-ip 172.16.0.254
#
vrrp group 1
add interface GigabitEthernet0/3 vrrp vrid 2 data transfer-only
add interface GigabitEthernet0/1 vrrp vrid 1 data
triggerdown interface GigabitEthernet0/0
triggerdown interface GigabitEthernet0/1
triggerdown interface GigabitEthernet0/2
vrrp-group enable
vrrp-group priority using-vrrppriority
vrrp-group preempt delay 0
undo vrrp-group group-send 

Alarm Information
none
Handling Process
1 check the connection of heartbeat, all right.
2 check the configuration, vrrp group 1 configured a lot of commands optional, deleted the commands un- essential, check the switch, the switch works normally.
3 add the command triggerdown interface GigabitEthernet0/0, the problem present again, so this command is the cause.
Root Cause
1 configuration has problems
2 heartbeat interface connect un-normal result in the switch of HRP failed
Suggestions

When we configure the two-node cluster hot backup,the equipment on the mode of router, triggerdown interface isn’t advised to configure; on the mode hybrid, triggerdown interface can urge the DOWM and UP of one interface Ethernet.

END