Interface ADSL can’t configure the PVC command

Publication Date:  2012-09-17 Views:  207 Downloads:  0
Issue Description
User connect with the private line by the ADSL interface card, the mode of obtain the address is that the upstream support the fix IP, no need to dial-up by using the account and the password. When configure the interface card, the command of PVC failed, the commands are as below:

interface Atm2/0/0
pvc 8/35
map bridge Virtual-Ethernet1

input the commands failed:
[USG2130BSR-Atm2/0/0]pvc ?
  <0-255>/<32-65535>  Enter value of  VPI/VCI
[USG2130BSR-Atm2/0/0]pvc 8/35
Error: Set failed!

Alarm Information
NONE
Handling Process
1. The interface don’t know the pvc 8/35, it’s means that is single PVC,we can change it by modify pvc. But after the input of this command, when we input map bridge Virtual-Ethernet1, clew that this operation isn’t supported.
[USG2130BSR-atm-pvc-Atm2/0/0-8/35]map bridge Virtual-Ethernet 1
Info:This card does not support this operation.
2. the interface card is single PVC, so the interface ATM no need to configure the pvc 8/35, means that no need to configure the map bridge Virtual-Ethernet1, we can configure the fix IP supplied by the upstream. 
Root Cause
1. ADSL interface card abnormity
2. Configuration un-correct
3. Equipment not support etc.
Suggestions
PVC command is used for the multi-PVC of the ATM interface, no need to tie up the VT port.

END