After configure the ip address of the X86 interface in the UAG and TSM’s combination, why can’t connect it.

Publication Date:  2012-09-19 Views:  176 Downloads:  0
Issue Description
By the console port initialize the UAG and TSM’s combination, and configure the ip address of the X86 interface ESP. but still can’t connect the TSM server of X86 interface
Alarm Information
none
Handling Process
Check the ip address on the GigabitEthernet 5/0/0 interface.Find that this ip and the ip on the X86 interface is not in the same network segment. Then, the network connect successfully after modifying the ip address, and access the TSM server normally.
Root Cause
The USG2200TSM communicate with the X86 interface by the virtual interface GigabitEthernet 5/0/0. The X86 interface do the inside communication with the GigabitEthernet 5/0/0.so when you configure ip address of the X86 interface, you must configure ip address on the GigabitEthernet 5/0/0 and they must in the same network segment. Or the TSM agent can’t connect the TSM controller for the identity authentication. The administrator can’t connect the X86 interface to do remote management by Telnet
Suggestions
none

END