FAQ-How to determine whether the switch physical interface is combo opto-electronic complex port, and the default type?

Publication Date:  2012-09-20 Views:  352 Downloads:  0
Issue Description
None
Alarm Information
 How to determine whether the physical interface of the switch is combo opto-electronic complex port as well as the default type is what? 
Handling Process
 Combo ports are optical opto-electronic complex interface, can switch electrical port mode and optical port mode in need .
1. How to determine the switch physical interface is Combo port?
(1) Through the switch panel to determine, the two ports interface identification and number are same ,and medium is different, so the two ports are combo ports .
(2) View the command line, display interface interface-type x / x / x
For example:
[Quidway] display interface 2/0/0
GigabitEthernet2/0/0 current state: DOWN
Line protocol current state: DOWN
Switch Port, PVID: 1001, TPID: 8100 (Hex), The Maximum Frame Length is 9216
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 4c1f-cc7c-8251
Last physical up time: -
Last physical down time: 2012-06-29 10:32:19
Current system time: 2012-06-29 10:35:39
Port Mode: COMBO AUTO / / the interface is Combo type, automatic switching
Current Work Mode: COPPER / / the interface is  electrical interface mode
Speed: 1000, Loopback: NONE
Duplex: FULL, Negotiation: ENABLE
Mdi: AUTO
......

2.Switch Combo default type and conversion command summary:
(1) V100R003 and previous versions, Combo port default type is optical port;
(2) V100R005 and later versions, Combo port default type is automatic switching, interface type is first insert first used.
Conversion command: Interface view combo-port {auto (automatic) | copper (electrical interface) | fiber (optical interface)}.
Root Cause
None
Suggestions
None

END