The camera is connected to the switch and the switch is power on.
1) Remove anti-theft screws from the camera using the hexagon screwdriver delivered with the dome camera and then remove the dome cover, as shown in Figure 1.
Figure 1 Removing the anti-theft screws
2) Adjust the angle, distance, and resolution for the camera.
a. Connect the RCA video output port to the test monitor. (3) in Figure 2 shows an RCA video output port.
b. Connect the other end of the network cable to any network port on the switch (powered in PoE mode). Power on the switch to power the camera.
c. Assign one person to observe the monitor, and another person to adjust the camera to cover the position to be monitored, as shown in Figure 2.
d. Assign one person to observe the monitor and another to adjust the distance of displayed picture by rotating button 2. (2) in Figure 2 shows button 2.
e. Assign one person to observe the monitor and another to adjust the distance of displayed picture by rotating button 1. (1) in Figure 2 shows button 1.
Figure 2 Adjusting the camera
For details about how to install the camera and connect cables to it, refer to your delivered documents.
3) Reinstall the dome cover and tighten the screws, as shown in Figure 3.
Figure 3 Installing the anti-theft screws
After the installation is complete, keep the delivered hexagon screwdriver that comes with the camera, and it needs to use when commissioning and maintenance the camera.