(TP3206) Unwanted Object During Hard Image Stitching

Publication Date:  2015-08-07 Views:  142 Downloads:  0
Issue Description
During hard image stitching, an unwanted object is displayed on an HD display, as shown in Figure 2-7. Analysis indicates that the object is reflected by another camera prism.

Figure 2-7 Unwanted object


Handling Process
Step 1 Check whether the unwanted object is displayed on the left or right of the HD display as you face the display.

Step 2 Based on the location of the unwanted object, perform either of the following:
  • If the unwanted object is on the left of the HD display, move the conference table leftward by approximately 80% of the width of the unwanted object.
  • If the unwanted object is on the right of the HD display, move the conference table rightward.
Step 3 After you move the conference table, perform hard image stitching again.
Root Cause
The distance or angle between the conference table and camera is incorrect.

END