No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Huawei V2 and V3 Server RAID Controller Card User Guide 36

This document describes the appearances and features of the redundant array of independent disks (RAID) controller cards, how to configure properties for the RAID controller cards, and how to install drivers. The RAID controller cards include the LSI SAS2208, LSI SAS2308, LSI SAS3008, LSI SAS3108, LSI SoftRAID, PM8060, and PM8068.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Initial Configuration (EFI/UEFI Mode)

Initial Configuration (EFI/UEFI Mode)

This section describes the management screen when Boot Type is set to EFI Boot Type or UEFI Boot Type on the Configuration Utility.

All configurations described in this document about the LSI SAS2208 are performed on the Configuration Utility, which can be accessed only after you restart the server. To monitor RAID status and view RAID configurations during system running, use the StorCLI tool.

If the boot type is changed after the OS has been installed in Legacy or UEFI mode, the OS will be inaccessible. To access the OS, you need to change the boot type to that used when the OS is installed. If the OS needs to be reinstalled, select the Legacy or UEFI mode based on actual situation.

If multiple boot devices are configured, you are advised to set Boot Type to UEFI Boot because certain boot devices may fail to boot if Boot Type is set to Legacy Boot. If you still want to set Boot Type to Legacy Boot, then disable redirection for certain serial ports or disable PXE for certain NICs based on the services in use. For details, see Setting PXE for a NIC and Setting Serial Port Redirection in the respective BIOS Parameter Reference.

Updated: 2019-11-01

Document ID: EDOC1000004186

Views: 745295

Downloads: 20659

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next