No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Huawei V2 and V3 Server RAID Controller Card User Guide 36

This document describes the appearances and features of the redundant array of independent disks (RAID) controller cards, how to configure properties for the RAID controller cards, and how to install drivers. The RAID controller cards include the LSI SAS2208, LSI SAS2308, LSI SAS3008, LSI SAS3108, LSI SoftRAID, PM8060, and PM8068.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking Consistency

Checking Consistency


A fault-tolerant virtual drive system requires a consistency check on a regular basis. A consistency check verifies the correctness and validity of redundant data on a RAID 1, 5, 6, 10, 50, or 60 array. You can start a consistency check for a RAID array on the Configuration Utility.


  1. Log in to the server through a remote virtual console and can manage the server on a real-time basis.
  2. Access the Configuration Utility main screen. For details, see Logging In to the Configuration Utility.
  3. Create a RAID array.
  4. Check consistency.

    1. On the left of the Configuration Utility main screen, select Virtual Drives.

      The virtual drive selection screen is displayed.

      Figure 4-172 Virtual drive selection screen
    2. Select Properties and click Go.

      The virtual drive property screen is displayed.

      Figure 4-173 Virtual drive properties
    3. Select CC under Operations, and click Go.

      Information shown in Figure 4-174 is displayed.

      Figure 4-174 Confirm
    4. Click Yes to start the consistency check.

      The Configuration Utility automatically corrects data errors or verification code errors detected in a consistency check. Back up all data before performing a consistency check.

    5. Click Home after the consistency check is complete.

    The Configuration Utility main screen is displayed.

Updated: 2019-11-01

Document ID: EDOC1000004186

Views: 704759

Downloads: 20579

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next