No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Huawei V2 and V3 Server RAID Controller Card User Guide 36

This document describes the appearances and features of the redundant array of independent disks (RAID) controller cards, how to configure properties for the RAID controller cards, and how to install drivers. The RAID controller cards include the LSI SAS2208, LSI SAS2308, LSI SAS3008, LSI SAS3108, LSI SoftRAID, PM8060, and PM8068.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Disk Utilities

Disk Utilities

On the Disk Utilities screen, you can check the current hard drive list and perform operations on specific hard drives, such as turning on indicators, formatting hard drives, and verifying data.

Screen Introduction

On the Configuration Utility screen shown in Figure 10-4, select Disk Utilities to display the hard drive list, as shown in Figure 10-168.

Select a hard drive and press Enter to display the operation menu, as shown in Table 10-33.

Figure 10-168 Hard drive list

Table 10-33 Operation menu

Operation

Description

Format Disk

Formats the hard drive, which takes a long time and clears all data in the drive. Formatting cannot be stopped once started.

NOTE:

This operation cannot be stopped once started, takes a long time, and will delete all data from the hard drive. Therefore, this operation is not recommended.

Verify Disk Media

Checks hard drive bad blocks to prevent bad block during use. Users can stop the operation by pressing Esc.

Identify Drive

Locates the hard drive.

Locating a Hard Drive

  1. Move the cursor to a specified hard drive and press Enter.
  2. On the displayed menu, select Identify Drive.

    Pressing any key will turn off the UID.

Translation
Download
Updated: 2019-11-01

Document ID: EDOC1000004186

Views: 712819

Downloads: 20606

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next