No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Huawei V2 and V3 Server RAID Controller Card User Guide 36

This document describes the appearances and features of the redundant array of independent disks (RAID) controller cards, how to configure properties for the RAID controller cards, and how to install drivers. The RAID controller cards include the LSI SAS2208, LSI SAS2308, LSI SAS3008, LSI SAS3108, LSI SoftRAID, PM8060, and PM8068.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Boot Device

Setting the Boot Device

Scenarios

If a hard drive is also configured as the boot device, the hard drive will be preferentially used as the boot device.

Prerequisites

Conditions

Data

Data preparation is not required for this operation.

Procedure

Set the boot device.

  1. On the Configuration Utility main screen, select Logical Device Configuration and press Enter.

    Main Menu is displayed, as shown in Figure 11-26.

    Figure 11-26 Main Menu

  2. Select Manage Arrays and press Enter.

    The array list is displayed.

  3. Select the array whose LD will be configured as the boot device and press Enter.

    The LD list of the array is displayed.

  4. Select the LD to be configured as the boot device and press Ctrl+B to adjust the LD location.

    As shown in the LD list, the LD has been adjusted to the first line.

When the array is in the rebuilding or initializing state, the LD location cannot be adjusted.

Exit the Configuration Utility.

Press Esc to exit the Configuration Utility and restart the server.

Translation
Download
Updated: 2019-11-01

Document ID: EDOC1000004186

Views: 760439

Downloads: 20686

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next