No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Huawei V2 and V3 Server RAID Controller Card User Guide 36

This document describes the appearances and features of the redundant array of independent disks (RAID) controller cards, how to configure properties for the RAID controller cards, and how to install drivers. The RAID controller cards include the LSI SAS2208, LSI SAS2308, LSI SAS3008, LSI SAS3108, LSI SoftRAID, PM8060, and PM8068.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Deleting a RAID Array

Deleting a RAID Array

Scenarios

If a RAID array is not required, you can delete it to release hard drives.

A deleted RAID array cannot be restored. Exercise caution when deleting a RAID array.

Procedure

  1. Access the Configuration Utility main screen. For details, see Logging In to the Configuration Utility.
  2. Log in to the virtual drive property screen.

    1. On the main screen, select Virtual Disk Management and press Enter.
    2. Select Select Virtual Disk Operations and press Enter.

      The virtual drive property screen is displayed, as shown in Figure 5-58.

      Figure 5-58 Virtual drive operations

  3. Delete a RAID array.

    1. Select Select Virtual Disk and press Enter.
    2. Select a RAID array to be deleted and press Enter.
    3. Use and to select Delete Virtual Disk and press Enter.

      A confirmation screen is displayed.

    4. Use and to select Confirm and press Enter.

      The drive status changes to [X].

    5. Use and to select Yes and press Enter.

      The message "Operation completed successfully" is displayed.

    6. Press Enter.

      The configuration is complete.

Translation
Download
Updated: 2019-11-01

Document ID: EDOC1000004186

Views: 714182

Downloads: 20610

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next