No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Huawei V2 and V3 Server RAID Controller Card User Guide 36

This document describes the appearances and features of the redundant array of independent disks (RAID) controller cards, how to configure properties for the RAID controller cards, and how to install drivers. The RAID controller cards include the LSI SAS2208, LSI SAS2308, LSI SAS3008, LSI SAS3108, LSI SoftRAID, PM8060, and PM8068.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Global Hot Spare Drive

Configuring a Global Hot Spare Drive

Scenarios

After hard drives of a server are configured with array properties, hot spare drives are configured to increase security and reduce impact on services caused by hard drive faults.

This section describes how to configure a hot spare drive.

Prerequisites

Conditions

Data

Data preparation is not required for this operation.

Procedure

Enter the hot spare drive Configuration Utility.

  1. On the Controller Operations main screen, select Logical Device Configuration and press Enter.

    The Logical Device Configuration screen is displayed, as shown in Figure 10-132.

    Figure 10-132 Logical Device Configuration screen

  2. Select Global Hotspares and press Enter.

    The system prompts that the hot spare drive must have a capacity greater than that of a member drive.

  3. Press any key to continue.

    The hot spare drive operation list is displayed, as shown in Figure 10-133.

    Figure 10-133 Operation list

    Add a hot spare drive.

  4. On the screen shown in Figure 10-133, select Add Spares and press Enter.

    The hard drive list is displayed, as shown in Figure 10-134.

    [ ] indicates an idle hard drive.

    Figure 10-134 Hard drive list

  5. Select an idle hard drive and press Enter.

    After the idle hard drive is selected, its status becomes [X].

  6. Select ADD and press Enter.
  7. Press any key to return to the screen shown in Figure 10-133.

    Exit the Configuration Utility.

  8. Press Esc to return to the Boot Manager screen.
Translation
Download
Updated: 2019-11-01

Document ID: EDOC1000004186

Views: 714978

Downloads: 20611

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next