No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Huawei V2 and V3 Server RAID Controller Card User Guide 36

This document describes the appearances and features of the redundant array of independent disks (RAID) controller cards, how to configure properties for the RAID controller cards, and how to install drivers. The RAID controller cards include the LSI SAS2208, LSI SAS2308, LSI SAS3008, LSI SAS3108, LSI SoftRAID, PM8060, and PM8068.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Boot Device

Setting the Boot Device

Scenarios

The boot items in the PM8060 can only be configured in Legacy or Dual mode.

This section describes how to set a created array as a boot item.

A single drive working as a boot device has a higher priority than an array.

Prerequisites

Conditions

Data

Data preparation is not required for this operation.

Procedure

  1. On the configuration tool main screen, select Logical Device Configuration and press Enter.

    The array configuration main screen is displayed.

    Figure 10-54 Array configuration main screen

  2. Select Manage Array and press Enter.
  3. Select an array that you want to configure as a boot item, and press Ctrl+B to change the boot priority.

    The first array in the list is the boot item.

    When an array is in the rebuild or initialization state, its boot priority cannot be changed.

  4. Press Esc when prompted to exit the configuration screen and restart the server.

Related Operations

If a server is configured with hard drive controllers of different chips, set the hard drive boot device on the BIOS.

Translation
Download
Updated: 2019-11-01

Document ID: EDOC1000004186

Views: 745305

Downloads: 20659

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next