No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Huawei V2 and V3 Server RAID Controller Card User Guide 36

This document describes the appearances and features of the redundant array of independent disks (RAID) controller cards, how to configure properties for the RAID controller cards, and how to install drivers. The RAID controller cards include the LSI SAS2208, LSI SAS2308, LSI SAS3008, LSI SAS3108, LSI SoftRAID, PM8060, and PM8068.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Hot Spare Drive

Configuring a Hot Spare Drive

Scenarios

This section describes how to configure a global hot spare drive for the LSI SAS3008IR.

After you have created a RAID 1, RAID 1E or RAID 10 array for the LSI SAS3008IR, you can configure one or two global hot spare drives to enhance data security.

The LSI SAS3008IR does not support dedicated hot spare drives.

Impact on the System

Data on the hard drives to be added to the RAID array will be lost. Back up data in advance.

Prerequisites

Conditions

  • An idle hard drive can be configured as a hot spare drive, but a RAID member drive cannot be configured as a hot spare drive.
  • A hot spare drive must be a SATA or SAS drive, and it must have at least the capacity of the RAID member drive with the largest capacity.
  • All RAID levels except RAID 0 support hot spare drives.

The following requirements must be met before you configure hot spare drives:

  • The server has idle hard drives.
  • You have logged in to the Configuration Utility.

Data

Data preparation is not required for this operation.

Procedure

  1. Access the Configuration Utility main screen. For details, see Logging In to the Configuration Utility.
  2. Access the virtual drive properties screen.

    1. On the main screen, select Virtual Disk Management and press Enter.
    2. Select Manage Virtual Disk Properties and press Enter.

      The virtual drive properties screen is displayed, as shown in Figure 6-54.

      Figure 6-54 Virtual drive properties

  3. Configure a hot spare drive.

    1. Select Manage Global Hotspare Disks and press Enter.

      The screen for managing hot spare drives is displayed, as shown in Figure 6-55.

      Figure 6-55 Configuring a hot spare drive
    2. Use and to select a physical drive and press Enter.
    3. Select Enabled and press Enter.
    4. Select the physical drive status to Disabled again.
    5. Use and to select Assign Global Hotspare Disk and press Enter.

      The message "Operation complete successfully" is displayed.

    6. Press Enter.

      The configuration is complete.

Translation
Download
Updated: 2019-11-01

Document ID: EDOC1000004186

Views: 746206

Downloads: 20661

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next