No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Huawei V2 and V3 Server RAID Controller Card User Guide 36

This document describes the appearances and features of the redundant array of independent disks (RAID) controller cards, how to configure properties for the RAID controller cards, and how to install drivers. The RAID controller cards include the LSI SAS2208, LSI SAS2308, LSI SAS3008, LSI SAS3108, LSI SoftRAID, PM8060, and PM8068.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Deleting a RAID Array

Deleting a RAID Array

Scenarios

If the server does not need a RAID array, you can delete the RAID array to release the hard drives.

A deleted RAID array cannot be restored. Exercise caution when deleting a RAID array.

Procedure

  1. Access the Configuration Utility main screen. For details, see Logging In to the Configuration Utility.
  2. Access the virtual drive properties screen.

    1. On the main screen, select Virtual Disk Management and press Enter.
    2. Select Select Virtual Disk Operations and press Enter.

      The virtual drive operation screen is displayed, as shown in Figure 6-61.

      Figure 6-61 Virtual drive operations

  3. Delete a RAID array.

    1. Select Select Virtual Disk and press Enter.
    2. Select a RAID array and press Enter.
    3. Use and to select Delete Virtual Disk and press Enter.

      A confirmation screen is displayed.

    4. Use and to select Confirm and press Enter.
    5. Use and to select Yes and press Enter.

      The message "Operation complete successfully" is displayed.

    6. Press Enter.

      The configuration is complete.

Translation
Download
Updated: 2019-11-01

Document ID: EDOC1000004186

Views: 704969

Downloads: 20579

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next