No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Huawei V2 and V3 Server RAID Controller Card User Guide 36

This document describes the appearances and features of the redundant array of independent disks (RAID) controller cards, how to configure properties for the RAID controller cards, and how to install drivers. The RAID controller cards include the LSI SAS2208, LSI SAS2308, LSI SAS3008, LSI SAS3108, LSI SoftRAID, PM8060, and PM8068.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Logging In to the Configuration Utility

Logging In to the Configuration Utility

Scenarios

This section describes how to log in to the Configuration Utility main screen of the PM8060.

Impact on the System

You need to restart the server before logging in to the Configuration Utility main screen. Services running on the server are interrupted.

Prerequisites

Conditions

None

Data

Data preparation is not required for this operation.

Documents

For details about how to log in to the screen by using the remote virtual console, see the user guides of specific servers.

Procedure

  1. Set the EFI mode. For details, see Setting the EFI/UEFI Mode.
  2. Log in to the Configuration Utility screen of the PM8060.

    The RAID controller card management interface position in EFI/UEFI mode varies with the BIOS platform.

  3. Select PMC maxView Storage Manager and press Enter.

    The PMC maxView Storage Manager screen is displayed, as shown in Figure 10-55.

    Figure 10-55 PMC maxView Storage Manager

  4. Press Enter.

    Device scanning starts, and the controller list is displayed, as shown in Figure 10-56.

    Figure 10-56 Controller list

    1. Select a controller and press Enter.

      The controller configuration management screen is displayed, as shown in Figure 10-57. Table 10-13 lists the operations that can be performed on the screen.

      Figure 10-57 Controller configuration management screen
      Table 10-13 Operations

      Operation

      Description

      Logical Device Configuration

      Configures arrays.

      Controller Settings

      Configures RAID controller card properties.

      Disk Utilities

      Configures hard drives.

      Administration

      Manages RAID controller card firmware.

Translation
Download
Updated: 2019-11-01

Document ID: EDOC1000004186

Views: 751082

Downloads: 20668

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next