No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Huawei V2 and V3 Server RAID Controller Card User Guide 36

This document describes the appearances and features of the redundant array of independent disks (RAID) controller cards, how to configure properties for the RAID controller cards, and how to install drivers. The RAID controller cards include the LSI SAS2208, LSI SAS2308, LSI SAS3008, LSI SAS3108, LSI SoftRAID, PM8060, and PM8068.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the EFI/UEFI Mode

Setting the EFI/UEFI Mode

Scenarios

Set the server boot mode to the EFI/UEFI mode when required.

Impact on the System

The server needs to be restarted, which will interrupt services.

Prerequisites

Conditions

You have logged in to the real-time server desktop through the remote virtual console of the management software (iBMC or iMana 200).

Data

None

Procedure

  1. Restart the server. Press Delete when the screen shown in Figure A-11 is displayed.

    The BIOS configuration screen is displayed.

    The default BIOS password is Huawei12#$.

    Figure A-11 Command prompt

  2. On the Boot screen, set the RAID controller card boot mode to the EFI/UEFI mode.
    • On a Grantley platform, set Boot Type to UEFI Boot Type, as shown in Figure A-12.
    Figure A-12 Setting the UEFI mode on a Grantley platform

    • On a Romley platform, set Boot Type to EFI Boot Type, as shown in Figure A-13.
    Figure A-13 Setting the EFI mode on a Romley platform

    • On a Brickland platform, set Boot mode select to UEFI and Storage to UEFI only, as shown in Figure A-14 and Figure A-15.
    Figure A-14 Setting the UEFI mode on a Brickland platform
    Figure A-15 Setting Storage

  3. Press F10 to save the settings.

    A confirmation dialog box is displayed.

  4. Select Yes and press Enter.

    The server restarts.

Translation
Download
Updated: 2019-11-01

Document ID: EDOC1000004186

Views: 756274

Downloads: 20680

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next