No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Huawei V2 and V3 Server RAID Controller Card User Guide 36

This document describes the appearances and features of the redundant array of independent disks (RAID) controller cards, how to configure properties for the RAID controller cards, and how to install drivers. The RAID controller cards include the LSI SAS2208, LSI SAS2308, LSI SAS3008, LSI SAS3108, LSI SoftRAID, PM8060, and PM8068.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Boot Device

Setting the Boot Device

Scenarios

To ensure that the server can start installed systems, you must set boot devices during RAID configuration.

  • If both configured, the first and second boot devices are started in sequence.
  • If only the first boot device is configured, the first boot device is started.
  • If only the second boot device is configured, the second boot device is started.

Procedure

  1. Access the Configuration Utility main screen. For details, see Logging In to the Configuration Utility.
  2. Set the boot device.

    1. On the Adapter Properties screen, select SAS Topology and press Enter.

      The SAS Topology screen is displayed.

    2. Use and to select a drive or RAID array, and press ALT+B to set the selected device as the first boot device.

      If hard drive or RAID array information is collapsed, move the cursor to Controller or RAID XX VOL and press Enter to expand the information.

      Boot is displayed in Device Info for the selected device, as shown in Figure 6-20.

      Figure 6-20 Setting the first boot device

    3. Press Esc to exit the current screen.
    4. On the confirmation screen, select Save changes then exit this menu and press Enter.

Related Operations

If a server is configured with only LSI SAS2308 and LSI SAS3008IR RAID controller cards, set the RAID controller card boot priority by following step 3 in Logging In to the Configuration Utility. If the server is configured with hard drive controllers of other chips, set the hard drive boot device on the BIOS.

Translation
Download
Updated: 2019-11-01

Document ID: EDOC1000004186

Views: 709398

Downloads: 20601

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next