No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Huawei V2 and V3 Server RAID Controller Card User Guide 36

This document describes the appearances and features of the redundant array of independent disks (RAID) controller cards, how to configure properties for the RAID controller cards, and how to install drivers. The RAID controller cards include the LSI SAS2208, LSI SAS2308, LSI SAS3008, LSI SAS3108, LSI SoftRAID, PM8060, and PM8068.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking Consistency

Checking Consistency


A fault-tolerant RAID system requires a consistency check on a regular basis. A consistency check verifies the correctness and validity of redundant data in RAID 1, 10, or 1E. You can start a consistency check for a RAID array on the Configuration Utility.


  1. Access the Configuration Utility main screen. For details, see Logging In to the Configuration Utility.
  2. Check consistency.

    1. On the Adapter Properties screen, select RAID Properties and press Enter.

      The Select New Volume Type screen is displayed, as shown in Figure 6-51.

      Figure 6-51 Select New Volume Type screen
    2. Select View Existing Volume and press Enter.

      The View Volume screen is displayed, as shown in Figure 6-52.

      Figure 6-52 View Volume screen
    3. Select Manage Volume and press Enter.

      The Manage Volume screen is displayed.

      Figure 6-53 Manage Volume screen
    4. Select Consistency Check and press Enter.

      The Consistency Check screen is displayed.

    5. Select an operation as required.
      • Press Y to start a consistency check.

        After the consistency check is complete, the Figure 6-10 screen is displayed.

      • Press N to quit.

        The Figure 6-71 screen is displayed.

Updated: 2019-11-01

Document ID: EDOC1000004186

Views: 706423

Downloads: 20585

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next