No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Huawei V2 and V3 Server RAID Controller Card User Guide 36

This document describes the appearances and features of the redundant array of independent disks (RAID) controller cards, how to configure properties for the RAID controller cards, and how to install drivers. The RAID controller cards include the LSI SAS2208, LSI SAS2308, LSI SAS3008, LSI SAS3108, LSI SoftRAID, PM8060, and PM8068.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Hard Drive Fault

Hard Drive Fault


A hard drive is faulty if any of the followings occurs:

  • The hard drive fault indicator is on.
  • After the server is powered on, the hard disk indicator is off.
  • A hard drive fault alarm was generated.


  1. Determine the slot number of the faulty drive.

    If a hard drive in JBOD mode is faulty, the Fault indicator on the drive will not be lit and the BMC will not generate an alarm.

    • Locate the faulty drive based on the fault indicator, which is steady orange. For details, see the drive numbering section in the user guide of the server you use.
    • Locate the faulty drive based on the iMana/iBMC drive alarm information. For details, see iMana/iBMC Alarm Handling.
    • Locate the faulty drive using the RAID controller card GUI. For details, see SAS Topology Menu or View Physical Disk Properties Screen.
    • Locate the faulty drive using the RAID controller card CLI tool. For details, see Querying RAID Controller Card/Physical Drive Information.

  2. Replace the drive.
Updated: 2019-11-01

Document ID: EDOC1000004186

Views: 757660

Downloads: 20686

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next