No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Huawei V2 and V3 Server RAID Controller Card User Guide 36

This document describes the appearances and features of the redundant array of independent disks (RAID) controller cards, how to configure properties for the RAID controller cards, and how to install drivers. The RAID controller cards include the LSI SAS2208, LSI SAS2308, LSI SAS3008, LSI SAS3108, LSI SoftRAID, PM8060, and PM8068.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Foreign Configuration

Foreign Configuration

Foreign configuration is different from the configuration of the current RAID controller card and is specified as Foreign Configuration on the configuration interface.

Generally, foreign configuration is involved in the following scenarios:

  • If RAID configuration exists on a physical drive newly installed on a server, the RAID controller card identifies the RAID configuration as foreign configuration.
  • After the RAID controller card of a server is replaced, the new RAID controller card identifies the existing RAID configuration as foreign configuration.
  • After the hot swap of a member drive in a RAID array, the member drive is identified as containing foreign configuration.

You can process detected foreign configuration as required. For example, if the RAID configuration existing on the newly installed hard drive does not meet requirements, you can delete it. If you want to use the RAID configuration of a RAID controller card that has been replaced, you can import the RAID configuration and make it take effect on the new RAID controller card.

Updated: 2019-11-01

Document ID: EDOC1000004186

Views: 712824

Downloads: 20606

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next