No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Huawei V2 and V3 Server RAID Controller Card User Guide 36

This document describes the appearances and features of the redundant array of independent disks (RAID) controller cards, how to configure properties for the RAID controller cards, and how to install drivers. The RAID controller cards include the LSI SAS2208, LSI SAS2308, LSI SAS3008, LSI SAS3108, LSI SoftRAID, PM8060, and PM8068.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Administration

Administration

On the Administration screen, you can upgrade RAID controller card firmware and view firmware parameters.

Screen Introduction

On the Configuration Utility screen shown in Figure 10-57, select Administration to display the Administration screen, as shown in Figure 10-188. The parameters are described in Table 10-44.

Figure 10-188 Administration screen
Table 10-44 Parameters on the Administration screen

Parameter

Description

FW update from Media

Upgrades RAID controller card firmware.

Save Support Archive

Saves support documentation.

CPLD Information

Displays CPLD version information.

PBSI Information

Allows you to query and set PBSI information.

Slave address: Press Enter to set the information.

PBSI Frequency: Press Enter to display a list, and select 0 kHz, 10 kHz, 100 kHz, 400 kHz, or 800 kHz from the list.

Clock Stretch: Select Enabled or Disabled.

Select Protocol: Select PBSI or Multi-Channel Transmission Platform (MCTP).

Boot Configuration Table Information

Provides information about the boot configuration table.

Upgrading RAID Controller Card Firmware

  1. Log in to the remote console of the server.
  2. Mount the PM8060 firmware file by using the virtual DVD drive or FDD.
  3. Restart the server and log in to the Figure 10-188 screen.
  4. Select FW update from Media and press Enter.

    Upgrade the firmware when prompted.

  5. Restart the server.
Translation
Download
Updated: 2019-11-01

Document ID: EDOC1000004186

Views: 758000

Downloads: 20686

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next