No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Huawei V2 and V3 Server RAID Controller Card User Guide 36

This document describes the appearances and features of the redundant array of independent disks (RAID) controller cards, how to configure properties for the RAID controller cards, and how to install drivers. The RAID controller cards include the LSI SAS2208, LSI SAS2308, LSI SAS3008, LSI SAS3108, LSI SoftRAID, PM8060, and PM8068.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Boot Device

Setting the Boot Device


This section describes how to set the boot device.

If HDD is configured as the system boot device in the BIOS and a RAID configuration exists, the system boots from the first RAID array by default. To change the boot drive, perform the following steps:




Data preparation is not required for this operation.


  1. On the Configuration Utility main screen, choose Configure > Select Boot Drive and press Enter.

    The boot drive list is displayed as shown in Figure 9-41.

    Figure 9-41 Boot device list

  2. Select a drive and press Enter.

    When the configuration is complete, "Boot Drive Information Is Saved" is displayed.

  3. Press Esc to exit the drive list.
  4. Press Esc to exit the Configuration Utility main screen.
  5. Restart the server.
Updated: 2019-11-01

Document ID: EDOC1000004186

Views: 759575

Downloads: 20686

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next