No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Huawei V2 and V3 Server RAID Controller Card User Guide 36

This document describes the appearances and features of the redundant array of independent disks (RAID) controller cards, how to configure properties for the RAID controller cards, and how to install drivers. The RAID controller cards include the LSI SAS2208, LSI SAS2308, LSI SAS3008, LSI SAS3108, LSI SoftRAID, PM8060, and PM8068.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Deleting a Hot Spare Drive

Deleting a Hot Spare Drive


  1. Access the Configuration Utility main screen. For details, see Logging In to the Configuration Utility.
  2. Access the virtual drive properties screen.

    1. On the main screen, select Virtual Disk Management and press Enter.
    2. Select Manage Virtual Disk Properties and press Enter.

      The virtual drive properties screen is displayed, as shown in Figure 6-56.

      Figure 6-56 Virtual drive properties

  3. Delete a hot spare drive.

    1. Select Manage Global Hotspare Disks and press Enter.

      The screen for managing hot spare drives is displayed, as shown in Figure 6-57.

      Figure 6-57 Deleting a hot spare drive
    2. Use and to select a hot spare drive and press Enter.
    3. Select Enabled and press Enter.
    4. Select the physical drive status to Disabled again.
    5. Use and to select Unassign Global Hotspare Disk and press Enter.

      The message "Operation complete successfully" is displayed.

    6. Press Enter.

      The configuration is complete.

Updated: 2019-11-01

Document ID: EDOC1000004186

Views: 747678

Downloads: 20661

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next