No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Huawei V2 and V3 Server RAID Controller Card User Guide 36

This document describes the appearances and features of the redundant array of independent disks (RAID) controller cards, how to configure properties for the RAID controller cards, and how to install drivers. The RAID controller cards include the LSI SAS2208, LSI SAS2308, LSI SAS3008, LSI SAS3108, LSI SoftRAID, PM8060, and PM8068.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Viewing the Topology

Viewing the Topology

Procedure

  1. Access the Configuration Utility main screen. For details, see Logging In to the Configuration Utility.
  2. Viewing the Topology.

    1. On the Adapter Properties screen, select SAS Topology and press Enter.

      The SAS Topology screen is displayed, as shown in Figure 5-51.

      Figure 5-51 SAS Topology screen

Hard Drive Indicators On

  1. Select a hard drive and press Enter.

    The indicators of the selected hard drive are on.

Formatting and Verifying a Hard Drive

  1. Select a hard drive and press ALT+D.

    The Device Properties screen of the selected hard drive is displayed, as shown in Figure 5-52.

    Figure 5-52 Device Properties screen

    The Device Properties screen provides the following operation options:

    • Format: formats a hard drive.
    • Verify: View the hard drive health status to check whether there are damaged or bad sectors.

Setting the Boot Device

  1. Select a hard drive and select an operation as required.

    • ALT+B:

      Sets the hard drive as the first boot device.

      Boot is displayed in Device Info for the selected device, as shown in Figure 5-53.
      Figure 5-53 Setting the first boot device
      • ALT+A:

        Sets the hard drive as the second boot device.

        Alt is displayed in Device Info.

Translation
Download
Updated: 2019-11-01

Document ID: EDOC1000004186

Views: 712552

Downloads: 20606

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next