No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S5700 Series Switches Hardware Description

This document provides an overall description of the S5700 hardware, helping you obtain detailed information about each chassis, card, power module, fan module, cable, and optical module.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Dedicated Stack Cable

Dedicated Stack Cable

Types of Dedicated Stack Cables

Table 9-18 lists the applicable dedicated stack cables.

Table 9-18 Dedicated stack cables

Model

Length

Electrical Attribute

Bend Radius

Connector Type

Part Number

SFP-10G-CU0M5 0.5 m Passive 25 mm SFP+ to SFP+ 02311VGK
SFP-10G-CU1M5 1.5 m Passive 25 mm SFP+ to SFP+ 02311VGN

Appearance and Structure

Figure 9-36 shows the appearance of a dedicated stack cable.

Figure 9-36 Dedicated stack cable appearance

Each dedicated stack cable has a Master tag on one end, and the untagged end is the slave end.

Figure 9-37 shows the structure of a dedicated stack cable.

Figure 9-37 Dedicated stack cable structure

Stack Setup

Dedicated stack cables can only be used to connect certain switch models, enabling them to set up a stack without manual configuration. For details on how to connect the stack cables, see the printed Dedicated Stack Cable Connection Guide delivered with the cables.

Before setting up a stack, confirm the stack connection mode supported by the member switches, as well as the hardware and software requirements. For details, see "Determining the Stack Connection Support and Mode" under "Typical Stack Configuration of Fixed Switches" in the Typical Configuration Examples.

Translation
Download
Updated: 2019-08-19

Document ID: EDOC1000013597

Views: 521985

Downloads: 13933

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next