No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CX116 Pass-Through Module V100R001 User Guide 16

This document describes the CX116 gigabit Ethernet (GE) pass through module of the Tecal E9000 server (short for E9000) in terms of its features, installation, removal, and maintenance.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Logging In to a Server Over a Network Port by Using PuTTY

Logging In to a Server Over a Network Port by Using PuTTY


Use PuTTY to remotely log in to a server over a local area network (LAN) and to configure and maintain the server.


The server in this topic can be a management module, compute node, or switching plane.


  1. Set an IP address and a subnet mask or add route information for the PC so that the PC can properly communicate with the server.

    You can run the Ping Server IP address command on the PC command-line interface (CLI) to check the communication between the PC and the server.

  2. Double-click PuTTY.exe.

    The PuTTY Configuration window is displayed.

    Figure 5-1 PuTTY Configuration window

  3. Set the login parameters.

    The parameters are described as follows:

    • Host Name (or IP address): Enter the IP address of the server to be logged in to, for example,
    • Port: Retain the default value 22.
    • Connection type: Retain the default value SSH.
    • Close window on exit: Retain the default value Only on clean exit.

    Set Host Name and Saved Sessions, and click Save. In the future use, double-click the saved record in Saved Sessions to log in to the server.

  4. (Optional) After logging in to the Ethernet plane by using PuTTY, if you fail to delete characters on the CLI by using the Backspace key, choose Terminal > Keyboard, and select Control-H under The Backspace key.

    Figure 5-2 PuTTY Configuration

  5. Click Open.

    The PuTTY window and login as: are displayed, waiting for you to enter a user name.

    • If you log in to the target server for the first time, the PuTTY Security Alert window is displayed. If you trust this site, click Yes. Then the PuTTY window is displayed.
    • If the entered user name is incorrect during server login, the PuTTY must be reconnected.

  6. Enter a user name and password by following instructions.

    After login, the server host name is displayed on the left of the prompt.

Updated: 2018-09-20

Document ID: EDOC1000015889

Views: 11998

Downloads: 487

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next